How to Program 2014 VW Passat AKL via Lonsdor K518ISE

 

Question
How to program 2014 VW Passat all keys lost in engineering mode with Lonsdor K518ISE Key Programmer? And how to get its IMMO data?

Procedure
Note: It does not support MQB all key lost.
Please go into engineering mode firstly:
Immobilization >> VW >> IMMO4 >> Select IMMO manually >> Engineering mode(4th Gen)

Step1. Use a VAG OBD Helper to read vehicle information and calculate data.
If VAG OBD Helper cannot read the data, which means it does not support.

Step2. Put the data into custom file of Lonsdor K518 after calculating.

Step3. Perform “Make Dealer Key”.

Step4. Perform “Add key(OBD)”.

Hope this is helpful.

How to Program Jaguar X-type 05 All Keys Lost

How-to: Jaguar X-type 2005 Tibbe FO21 All Keys Lost programming.

What tools:

FO21 Tibble lock decoder to open car

Cut key with Xhorse condor xc-mini plus key cutting machine

Generate remote with keydiy kd-x2

Generate transponder with VVDI Key Tool

Program key to car with Autel IM608/IM508

How-to:

1.Open car with FO21 tibbe lock decoder
2. Decoding
Code: 2-4-3-4-1-2

The rear ring moves the front PIN.
Note the direction when milling

3. cutting key with xhorse condor mini plus and M3 clamp

Select Cut by bitting- FO21- Jaguar
Inutbititng and cut key

customer wants 2 remote keys, 1 flip key and 1 non flip

4. Generate remote with Keydiy KD-X2

generate without battery
Select Generate Remote- Jaguar- 433MHz- Generate

5.
Generate transponder with vvdi key tool or mini key tool
use super chip xt27 to generate 4D60

put super chip into indiction coil
in vvdi key tool, select Transponder clone
It read ID46 chip and says it is cloneable
Select Generate transponder -4D -ID60

Generate transponder success

install the non flip remote

test frequency, it shows 434MHz

6. Last step we need to match keys to the immobilizer with autel im608 or im508
insert key and turn on ignition switch
Select Immo- Jaguar – Automatic selection
VIN is read

confirm vehicle information
Immo status scan

Follow IM608 prompts to program key2 and key 3 until finished.

Test new keys.